When driving a truck for a long time, the clutch is in a half-stepped state. In order to reduce the wear and tear of the car's clutch plate, the clutch pedal should be used correctly.
First of all, don't press the clutch pedal halfway, because this will put the truck's clutch plate in a half-clutch state, that is, the Frisbee and the pressure plate are in a state of friction. Second, when the truck is driving, if the clutch pedal is fully depressed, the flywheel and the pressure plate of the automobile clutch are completely separated, and there is no friction between the two.
If the clutch pedal is fully lifted, the flywheel and the car clutch pressure plate are fully engaged with little friction. That is, the pedal cannot be placed in a half-clutch state.
If the clutch pressure plate fails, in addition to normal wear, it is most likely a quality problem. The clutch plate and pressure plate are prone to wear and tear in long-term use and improper operation, such as frequent semi-linkage, large accelerator start, high-speed driving in low gear, etc.
If it is worn, the jitter start is caused by the serious wear of the clutch plate and the slipping of the pressure plate of the automobile clutch. If you don't replace it, the wear will get worse.
In addition, the damage of the friction plate leads to slippage at the start or poor driving, the engine speed is increased, and the speed of the vehicle cannot go up; the connection between the pressure plate and the friction plate is closed, and when the friction plate has problems, the wear of the pressure plate and the flywheel will be accelerated. The main performance is that it is difficult to shift gears, the separation is not clear, and the starting is jittery.
Taizhou Benwo Auto Parts Co., Ltd. A Clutch Cover supplier and Release Bearing Manufacturer from China. The company mainly sells Heavy Duty Truck Clutch series products and Scania Truck Parts. From material selection to factory inspection, the most complete international standards are adopted.